2009 Honda CR-V Back-Up Sensor Installation Instructions

Back-Up Sensors Installed on the Honda CR-V Vehicle.
NOTE: If you are also installing a trailer hitch, install the back-up sensor first.
1. Make sure you have the anti-theft codes for the radio and navigation system if equipped, then write down the radio presets.
2. Disconnect the negative cable from the battery.
3. If equipped, remove the tonneau cover.
4. Remove the right rear door sill trim (three clips).
5. Remove the trunk board (two hooks).
6. Remove the weatherstrip from around the rear trim panel. Remove the rear trim panel (two bolts with tie-down hooks, two clips, and four clips).
7. Fold the rear seats forward, and remove the right rear lid from the right cargo area side trim (10 retaining tabs).
8. Remove the vehicle bolt from the bracket of the right cargo area side trim panel.
9. Remove the rear door and tailgate weatherstrip from the right cargo area side and two clips from the trim panel.
10. Remove the right cargo area side trim panel (10 clips).
11. Remove the seat belt from the right quarter pillar trim (one cover and one vehicle bolt).
12. Remove the right quarter pillar glass trim (seven clips).
13. Remove the left rear splash guards (four self-tapping screws).
14. Remove the right rear splash guard (four self-tapping screws).
15. With the help of an assistant, remove the rear bumper (two bolt covers, two bolts, two flange bolts, and three clips).
16. Get the back-up sensor harness, and attach the 2 A fuse label (2 A) to the fuse case.
17. Install the cargo area, remove the clip that secures the vehicle 6-pin connector to the vehicle panel, and disconnect the vehicle 6-pin connector.
18. Plug the back-up sensor 6-pin connector into the vehicle 6-pin connector. Plug the other vehicle 6-pin connector into the other back-up sensor harness 6- pin connector.

Source