Inner-Edge Interior Lightbar Installation Guide

Installation:
Note: When routing the wires, it is important to choose a path that will keep the wires away from excessive heat or any vehicle equipment that could compromise the integrity of the wires (ex. trunk lids, door jams, etc.)
1. Using an appropriately sized Torxо head screwdriver, loosen the three screws securing the driver-side visor swivel bracket to the vehicle. Do not remove these screws.
2. Remove the screws securing the visor clip to the vehicle. Remove and retain the clip and all hardware.
3. Locate the driver-side mounting bracket (indicated with a “D” label) and orient as shown (see Fig.1).
4. Slide the mounting bracket fingers between the loosened swivel bracket and the headliner. The bracket fingers should straddle the inner section of the swivel bracket when properly oriented.
5. Position the keyed opening of the mounting bracket directly under the mounting location for the visor clip removed in step 2. With the bracket in this position, re-mount the visor clip in its original location using the original hardware.
6. Firmly tighten any hardware loosened in this procedure.
7. Repeat this procedure for the passenger-side mounting bracket (indicated with a “P” label).
8. Position the lightbar as shown in Fig. 1. Using the hardware provided (#10-32 x 3/8” black oxide screws), secure the lightbar to the mounting brackets. Tighten this hardware firmly.
9. Route the lightbar cable down the vehicle A-pillar and to your control head.
10. Make all necessary wiring connections using the information provided.

source