All instructions assume a drivers seat vantage point. Caution is advised when removing and reassembling wood or plastic parts of a dash. Applying unnecessary force or pressure may cause a piece to crack or break.
Pro.Fit logo and part number will be right side up and readable when installed.
TOOLS REQUIRED: Hook tool, 9/32” socket and driver.
PARTS INCLUDED: Pro.Fit VSMTM, instructions.
LOCATION: To the right of the radio.
STEP 1. Begin by inserting hook tool under cover for ignition switch and pulling back to release two (2) clips Set cover aside. Starting by ignition switch, insert hook tool behind trim bezel which surrounds the climate control and radio and pull toward you to release two (2) clips. Continue working bezel loose with hands until removed. Do not disconnect wiring. Let bezel hang.
STEP 2. With 9/32” socket and driver locate and remove the factory screw to right of the radio. Align Pro.Fit VSMTM over screw hole and centering pin. Insert factory screw and tighten.
STEP 3. Install trim bezel back into position. Put ignition cover back into position. Attach hang-up cup onto Pro.Fit VSMTM. This completes the installation of your Pro.Fit VSMTM.
Source
Tuesday, January 11, 2011
2001-2002 Chevrolet Malibu Part Number CV-52-01 Installation
1:12 PM by onesecond
·
Labels: bezel, Chevrolet, chevrolet malibu, hook, hook tool, point caution, screw hole, vantage point
Labels: bezel, Chevrolet, chevrolet malibu, hook, hook tool, point caution, screw hole, vantage point
Subscribe to:
Post Comments (Atom)
0 comments:
Post a Comment