1992-96 Toyota Camry Pro.Fit Part Number TY-50-92 Installation Instructions

All instructions assume a drivers seat vantage point. Caution is advised when removing and reassembling wood or plastic parts of a dash. Applying unnecessary force or pressure may cause a piece to crack or break. Pro.Fit logo and part number will be right side up and readable when installed.
TOOLS REQUIRED: #2 Phillips screwdriver, hook tool.
PARTS INCLUDED: Pro.Fit VSMTM, instructions.
LOCATION: To the right of the radio.

Remote Starter Integration for the 2007 Toyota Camry equipped with the Smart Key System with Push Button Start

Preparation the Toyota Camry for installation
-Remove the driver’s side under dash, as well as the knee airbag bolts. Move the Airbag aside, but DO NOT DISCONNECT the Airbag connector in order to avoid setting any vehicle codes.
-Remove the driver’s side floor heating duct, in order to access the vehicle IMI & IMO wires easily.
The remote car starter will be installed in a conventional manner even if the car is equipped with the Smart Key “Push-to-Start” system.

1999-2000 Toyota Camry Radio Replacement

The plastic dash panel surrounding the radio and air conditioner controls must be unsnapped from the dash in order to gain access to the bolts which secure the radio. Pull out the ashtray at the bottom of the plastic dash panel. With your hands, grab the bottom of the plastic dash panel below the ashtray location and pull firmly until the plastic dash panel begins to unsnap from the dash. Continue to pull the dash until the sides and top of the dash panel completely unsnap from the main dash assembly. The radio is secured to the dash with four (4) 10 mm bolt screws, (1) at each side corner of the radio. Locate and remove all four bolt screws. Pull the radio out of the dash. Unplug the black cable plugged into the rear of the radio. Unplug (2) white plastic wire harness connectors snapped into the rear of the radio. The radio can now be completely removed from the dash.

2007 Toyota Camry Hybrid Sirius XM Radio Satellite Installation

Cable Routing and Installation (a) Install and route the tuner cable from the center cluster and along the front support bar. (Fig. 3-1) (b) Provide sufficient cable slack to connect to the tuner, and then secure the cable to the existing wire harness with lock tie. Cut excess off lock tie. Connect wire harness to head unit. (c) Using lock ties attach to existing W /H. Trim lock tie excess. (Fig. 3-2) (d) Route to the existing clamps. (Fig. 3-2) (f) Route the cable as shown and secure with lock tie. Trim lock tie excess. (Fig. 3-4) (g) Route the tuner cable under the rear passenger seat and secure with cushion tape. (Fig. 3-5) NOTE:Clean the area for the cushion tape with the approved cleaner.

05 Toyota Camry SIRIUS Satellite Radio Operation Instructions

This section describes some of the basic features on Toyota audio systems. Some information may not pertain to your system. Your audio system works when the ignition key is in the “ACC” or “ON” position. TURNING THE SYSTEM ON AND OFF Push “PWR·VOL” to turn the audio system on and off. Push “AM”, “FM1”, “FM2”, “FM1·2”, “FM”, “SAT”*, “TAPE”, “CD” or “DISC” to turn on that function without pushing “PWR·VOL”. You can turn on each player by inserting a cassette tape or compact disc.