Remote Starter Integration for the 2007 Toyota Camry equipped with the Smart Key System with Push Button Start

Preparation the Toyota Camry for installation
-Remove the driver’s side under dash, as well as the knee airbag bolts. Move the Airbag aside, but DO NOT DISCONNECT the Airbag connector in order to avoid setting any vehicle codes.
-Remove the driver’s side floor heating duct, in order to access the vehicle IMI & IMO wires easily.
The remote car starter will be installed in a conventional manner even if the car is equipped with the Smart Key “Push-to-Start” system.

556H Honda/Acura Immobilizer Bypass Module

The Honda/Acura Immobilizer anti-theft system uses a low-power transponder mounted in the head of the ignition key. When the vehicle is started, the Key Cylinder Module converts the transponder signal and sends a secure, coded signal to the Engine Control Module. If the signal to the Engine Control Module is correct, the vehicle will start.

2008 Dodge Grand Caravan / Chrysler Town Dealer Installed Factory Remote Start Components

This instructional manual will discuss the installation of the hood switch harness & XBM (Remote Start) turn-on. Other steps will include replacement procedure of the WIN, antenna installation, hood switch installation, and uploading of vehicle configuration from Dealer Connect. Refer to the vehicle Service Manual for specific installation procedures for all components except the hood switch harness, which is covered here in detail.