Remote Starter Integration for the 2007 Toyota Camry equipped with the Smart Key System with Push Button Start

Preparation the Toyota Camry for installation
-Remove the driver’s side under dash, as well as the knee airbag bolts. Move the Airbag aside, but DO NOT DISCONNECT the Airbag connector in order to avoid setting any vehicle codes.
-Remove the driver’s side floor heating duct, in order to access the vehicle IMI & IMO wires easily.
The remote car starter will be installed in a conventional manner even if the car is equipped with the Smart Key “Push-to-Start” system.

2007 Toyota Camry Hybrid Sirius XM Radio Satellite Installation

Cable Routing and Installation (a) Install and route the tuner cable from the center cluster and along the front support bar. (Fig. 3-1) (b) Provide sufficient cable slack to connect to the tuner, and then secure the cable to the existing wire harness with lock tie. Cut excess off lock tie. Connect wire harness to head unit. (c) Using lock ties attach to existing W /H. Trim lock tie excess. (Fig. 3-2) (d) Route to the existing clamps. (Fig. 3-2) (f) Route the cable as shown and secure with lock tie. Trim lock tie excess. (Fig. 3-4) (g) Route the tuner cable under the rear passenger seat and secure with cushion tape. (Fig. 3-5) NOTE:Clean the area for the cushion tape with the approved cleaner.