Dodge 5.9L Cummins CP3 High Pressure Fuel Injection Pump

Removing your old pump
Note: Do your best to keep all components as clean as possible.
1. Disconnect the negative battery cables from all batteries.
2. Remove the intake manifold (above injection pump) and its hose.
3. Remove the 5 ECM (Engine Control Module) mounting bolts (located on the lower left side of the engine block towards the front). Do NOT disconnect the wiring connectors from the ECM.

96-00 Honda Civil Door Panel Removal & Installation

Remove the screw from behind the interior door handle Slide out the door handle trim as shown Removing the door panel from the passenger side door View of the inside of the door, panel removed 1. Remove the screw from the door handle trim. 2. Slide the handle assembly forward and out to access the lock rod clip. 3. Release the clip 4. Disconnect the door lock switch 5. Remove the door opener handle assembly. 6. Carefully pry at the small opening on the bottom of the speaker grill. 7. Remove the speaker grille. 8. Remove the speaker mounting screws. 9. Detach the electrical connector and remove the speaker. 10. Remove the screws in the armrest. 11. Remove the center from the trim clip at the upper front of the door panel and remove the clip. 12. Using a suitable trim panel removal tool, unsnap the door panel from the door frame. 13. Carefully lift the door panel up and away from the door frame. To install: 14. Installation is the reverse of the removal procedure.

2005 Ford Taurus Engine Controls Vacuum Leakage Noise Possible DTC's

Some 2005 Taurus and Sable vehicles equipped with a 3.0L 2V and some 2003-
2005 Lincoln LS vehicles equipped with a 3.0L 4V engine may exhibit a vacuum
leakage noise or lean codes and/or malfunction indicator lamp (MIL) on. The
cause may be a leak at the 0-ring on the intake manifold tuning (IMT) valve.
ACTION
Follow the Service Procedure steps to correct the condition.

1994 Ford Taurus Ignition Switch Removal Service and Repair

REMOVAL 1. Disconnect battery ground cable. 2. Remove four or five steering column shroud attaching screws, then the shroud. 3. Remove tilt lever, if equipped. 4. Remove instrument panel lower steering column cover. 5. Disconnect ignition switch electrical connector. 6. Place lock cylinder in RUN position, then remove two ignition switch attaching screws. 7. Disengage ignition switch from actuator pin.

1994-1996 Cadillac DeVille 50G-4-2 4 Wheel Conversion Kit Installation

BEFORE YOU BEGIN THE REMOVAL OR INSTALLATION, READ ALL INSTRUCTIONS THOROUGHLY! THE WARRANTY WILL BE VOID IF INSTRUCTIONS ARE NOT FOLLOWED EXACTLY. DO NOT WORK UNDER CAR UNDER A VEHICLE SUPPORTED BY A JACK. ALWAYS SUPPORT THE VEHICLE ON SAFETY STANDS.
1. Raise and support vehicle, allowing suspension to hang free.
2. Remove the wheel.
3. Disconnect the shock absorber electrical connector.

2008 Ford Truck Escape 2WD V6-3.0L Blower Motor Resistor Service and Repair

2008 Ford Truck Escape 2WD V6-3.0L Vehicle Level Heating and Air Conditioning Blower Motor Resistor Service and Repair
Removal and Installation
1. Lower the glove compartment.
2. Disconnect the blower motor resistor electrical connector.
3. Remove the 2 blower motor resistor screws.

Chrysler 727 and 904 Pro Brake Part Installation

Your Chrysler 727 / 904 Pro Brake valvebody is designed to have a reverse lockout safety feature. To engage reverse, the shifter must be placed in reverse and the Trans brake switch must be depressed simultaneously. Install a good bolt-in sprag! If necessary, refer to a transmission manual for detailed instructions on disassembly and reassembly. The transmission should be completely disassembled, and thoroughly cleaned.