Removal and Installation
1. Disconnect the battery ground cable.
2. Remove the front door trim panel screws.
3. NOTE: The front door trim panel has five two-part pin-type retainers. Then male part of the trim retainer will remain with
Showing posts with label ford taurus. Show all posts
Showing posts with label ford taurus. Show all posts
Thursday, April 14, 2011
Saturday, May 29, 2010
2002 Ford Taurus Water in the Blower Case
11:36 PM by onesecond
·
0
comments
Labels: aa, blower motor resistor, cabin filter, climate control, cowl vent, failure, Ford, ford taurus, high speed, information issue, manual sections, pollen filter, rain hat, rh, rubber seal, silicone rubber, tsb, vehicle model, water corrosion, windshield
Labels: aa, blower motor resistor, cabin filter, climate control, cowl vent, failure, Ford, ford taurus, high speed, information issue, manual sections, pollen filter, rain hat, rh, rubber seal, silicone rubber, tsb, vehicle model, water corrosion, windshield
This article supersedes TSB 03-15-06 to update the vehicle model years and build date information.
ISSUE
Some vehicles built between 5/1/2001 and 12/15/2003 may exhibit water in the blower case or on the passenger side floor, an inoperative climate control blower motor, a motor that operates on high speed only, and/or a blower motor resistor
failure.
ISSUE
Some vehicles built between 5/1/2001 and 12/15/2003 may exhibit water in the blower case or on the passenger side floor, an inoperative climate control blower motor, a motor that operates on high speed only, and/or a blower motor resistor
failure.
2005 Ford Taurus Engine Controls Vacuum Leakage Noise Possible DTC's
11:30 PM by onesecond
·
0
comments
Labels: 0l, 2005 ford taurus, actuator, diagnosis, dtc, electrical connector, engine oil, Ford, ford taurus, indicator lamp, intake manifold, Lincoln, lincoln ls, procedure steps, retainers, sable, upper intake manifold, vacuum, valve action
Labels: 0l, 2005 ford taurus, actuator, diagnosis, dtc, electrical connector, engine oil, Ford, ford taurus, indicator lamp, intake manifold, Lincoln, lincoln ls, procedure steps, retainers, sable, upper intake manifold, vacuum, valve action
Some 2005 Taurus and Sable vehicles equipped with a 3.0L 2V and some 2003-
2005 Lincoln LS vehicles equipped with a 3.0L 4V engine may exhibit a vacuum
leakage noise or lean codes and/or malfunction indicator lamp (MIL) on. The
cause may be a leak at the 0-ring on the intake manifold tuning (IMT) valve.
ACTION
Follow the Service Procedure steps to correct the condition.
2005 Lincoln LS vehicles equipped with a 3.0L 4V engine may exhibit a vacuum
leakage noise or lean codes and/or malfunction indicator lamp (MIL) on. The
cause may be a leak at the 0-ring on the intake manifold tuning (IMT) valve.
ACTION
Follow the Service Procedure steps to correct the condition.
2000-2003 Ford Taurus Idle Air Control (IAC) Valve Diagnostics Service Tips
9:49 PM by onesecond
·
1 comments
Labels: accurate identification, crank, dtc, engine stall, Ford, ford taurus, hesitation, idle speed control, indicator lamp, service writer, steady speed, time source, valve diagnostics
Labels: accurate identification, crank, dtc, engine stall, Ford, ford taurus, hesitation, idle speed control, indicator lamp, service writer, steady speed, time source, valve diagnostics
Some vehicles, may exhibit drivability conditions. These may include: • No start • Difficult to start • Stall • Low idle • Rough idle • High idle • Hesitation/surge while accelerating or at steady speed
These conditions may be intermittent with no Diagnostic Trouble Codes (DTC) and no Malfunction Indicator Lamp (MIL). In some cases DTC and MIL may be evident.
These conditions may be intermittent with no Diagnostic Trouble Codes (DTC) and no Malfunction Indicator Lamp (MIL). In some cases DTC and MIL may be evident.
Friday, May 28, 2010
1994 Ford Taurus Ignition Switch Removal Service and Repair
11:27 PM by onesecond
·
0
comments
Labels: 1994 ford taurus, electrical connector, Ford, ford taurus, ground cable, holes, instrument panel, lock cylinder, screws, steering column locks, torque
Labels: 1994 ford taurus, electrical connector, Ford, ford taurus, ground cable, holes, instrument panel, lock cylinder, screws, steering column locks, torque
REMOVAL 1. Disconnect battery ground cable. 2. Remove four or five steering column shroud attaching screws, then the shroud. 3. Remove tilt lever, if equipped. 4. Remove instrument panel lower steering column cover. 5. Disconnect ignition switch electrical connector. 6. Place lock cylinder in RUN position, then remove two ignition switch attaching screws. 7. Disengage ignition switch from actuator pin.
Friday, May 14, 2010
2002 Ford Taurus V6-3.0L VIN U - A/C - Erratic/Inoperative Blower Case
10:43 PM by onesecond
·
0
comments
Labels: 0l, aa, blower motor resistor, cabin filter, climate control, cowl vent, failure, Ford, ford taurus, ford taurus v6, high speed, manual sections, pollen filter, rain hat, rh, rubber seal, silicone rubber, vin, water corrosion, windshield
Labels: 0l, aa, blower motor resistor, cabin filter, climate control, cowl vent, failure, Ford, ford taurus, ford taurus v6, high speed, manual sections, pollen filter, rain hat, rh, rubber seal, silicone rubber, vin, water corrosion, windshield
Some vehicles built between 5/1/2001 and 12/15/2003 may exhibit water in the
blower case or on the passenger side floor, an inoperative climate control blower
motor, a motor that operates on high speed only, and/or a blower motor resistor
failure.
ACTION
Inspect and seal cowl area and install Rain-Hat Extension Seal. Inspect and
replace blower motor and/or blower motor resistor if there is evidence of
water/corrosion. Refer to the following Service Procedure for details.
SERVICE PROCEDURE
blower case or on the passenger side floor, an inoperative climate control blower
motor, a motor that operates on high speed only, and/or a blower motor resistor
failure.
ACTION
Inspect and seal cowl area and install Rain-Hat Extension Seal. Inspect and
replace blower motor and/or blower motor resistor if there is evidence of
water/corrosion. Refer to the following Service Procedure for details.
SERVICE PROCEDURE
Subscribe to:
Posts (Atom)
