When performing service on or near the SIR components or the SIR wiring, the SIR system must be disabled. Failure to follow the correct procedure could cause air bag deployment, personal injury or unnecessary SIR system repairs. The full bodyside inner panel comes as a one piece assembly and can be replaced at factory seams after removal of outer panel, roof and glass. Any one of these procedures can be performed separately, or in any combination dependent upon the extent of damage to the vehicle.
Showing posts with label integrity. Show all posts
Showing posts with label integrity. Show all posts
Wednesday, June 16, 2010
2000-2005 Cadillar Deville Inner Front Pillar, Center Pillar and Rear Wheelhouse Sectioning
11:35 PM by onesecond
·
0
comments
Labels: air bag, air bag deployment, Cadillac, caution, center pillar, extent, failure, hinge, horizontal line, integrity, mm 2, necessary components, PDF Download, personal injury, rocker panel, seams, sir system
Labels: air bag, air bag deployment, Cadillac, caution, center pillar, extent, failure, hinge, horizontal line, integrity, mm 2, necessary components, PDF Download, personal injury, rocker panel, seams, sir system
Tuesday, June 1, 2010
96-00 Honda Civil Door Panel Removal & Installation
2:12 AM by onesecond
·
0
comments
Labels: 6mm, assembly source, bolt and nut, civic del sol, door handle, electrical connector, Honda, honda civic, honda civic del sol, honda civil, integrity, interior door, lock switch, rear doors, removal tool, rivet, rivets, screw, screws, speaker grille
Labels: 6mm, assembly source, bolt and nut, civic del sol, door handle, electrical connector, Honda, honda civic, honda civic del sol, honda civil, integrity, interior door, lock switch, rear doors, removal tool, rivet, rivets, screw, screws, speaker grille
Remove the screw from behind the interior door handle Slide out the door handle trim as shown Removing the door panel from the passenger side door View of the inside of the door, panel removed 1. Remove the screw from the door handle trim. 2. Slide the handle assembly forward and out to access the lock rod clip. 3. Release the clip 4. Disconnect the door lock switch 5. Remove the door opener handle assembly. 6. Carefully pry at the small opening on the bottom of the speaker grill. 7. Remove the speaker grille. 8. Remove the speaker mounting screws. 9. Detach the electrical connector and remove the speaker. 10. Remove the screws in the armrest. 11. Remove the center from the trim clip at the upper front of the door panel and remove the clip. 12. Using a suitable trim panel removal tool, unsnap the door panel from the door frame. 13. Carefully lift the door panel up and away from the door frame. To install: 14. Installation is the reverse of the removal procedure.
Subscribe to:
Posts (Atom)