BMW Owner's Manual for Bluetooth Upgrade Module

This manual is to be used as a complement to your BMW communication system handbook. Once you have successfully paired and connected your mobile phone to your BTUM using this manual, please refer to the communications system handbook included with your vehicle for complete instructions on operating the phone system. For operation of your mobile phone, please refer to the Owner’s Manual supplied with your mobile phone. Should the day arrive when you wish to sell your BMW, please remember to hand this Owner’s Manual to the next owner; it is an important part of the vehicle. If you have any additional questions, your BMW center will be glad to help you.

2000-2005 Cadillar Deville Inner Front Pillar, Center Pillar and Rear Wheelhouse Sectioning

When performing service on or near the SIR components or the SIR wiring, the SIR system must be disabled. Failure to follow the correct procedure could cause air bag deployment, personal injury or unnecessary SIR system repairs. The full bodyside inner panel comes as a one piece assembly and can be replaced at factory seams after removal of outer panel, roof and glass. Any one of these procedures can be performed separately, or in any combination dependent upon the extent of damage to the vehicle.

1994-1997 Cadillac Seville Revised HVAC Blower Motor Installation Procedures

The intent of this bulletin is to provide technicians information regarding the proper installation of the Heating, Ventilation and Air Conditioning (HVAC) Module blower motor (with impeller) assembly.
The current available HVAC Module blower motor for the above listed vehicles can be identified by the three mounting holes (1). The original equipment blower motor had five mounting holes.
In order to avoid confusion and ensure a high level of customer satisfaction, when replacing an HVAC Module blower motor, refer to this bulletin for the appropriate procedure.

1984 Chevrolet Corvette Fuel Injection System

FUEL INJECTION SYSTEM - DUAL UNIT TBI 1984 Fuel Injection GENERAL MOTORS ELECTRONIC - DUAL UNIT OVERHAUL DISASSEMBLY NOTE: Before performing any service on throttle body assembly, it is essential that throttle body be placed on a holding fixture (J-9789-118, BT 30-15 or equivalent) to prevent damage to throttle valve. Disassembly of each throttle body unit is the same. DO NOT interchange components between front and rear units.