When performing service on or near the SIR components or the SIR wiring, the SIR system must be disabled. Failure to follow the correct procedure could cause air bag deployment, personal injury or unnecessary SIR system repairs. The full bodyside inner panel comes as a one piece assembly and can be replaced at factory seams after removal of outer panel, roof and glass. Any one of these procedures can be performed separately, or in any combination dependent upon the extent of damage to the vehicle.
Showing posts with label seams. Show all posts
Showing posts with label seams. Show all posts
Wednesday, June 16, 2010
2000-2005 Cadillar Deville Inner Front Pillar, Center Pillar and Rear Wheelhouse Sectioning
11:35 PM by onesecond
·
0
comments
Labels: air bag, air bag deployment, Cadillac, caution, center pillar, extent, failure, hinge, horizontal line, integrity, mm 2, necessary components, PDF Download, personal injury, rocker panel, seams, sir system
Labels: air bag, air bag deployment, Cadillac, caution, center pillar, extent, failure, hinge, horizontal line, integrity, mm 2, necessary components, PDF Download, personal injury, rocker panel, seams, sir system
Friday, May 21, 2010
94-96 Cadillac DeVille Universal Taillight Kit Installation
2:58 AM by onesecond
·
0
comments
Labels: bezel, buckets, Cadillac, cadillac deville, fillers, holes, paint, plasma cutter, preference, repeat process, screws, seams, shape, taillight assemblies, wheel, work tools
Labels: bezel, buckets, Cadillac, cadillac deville, fillers, holes, paint, plasma cutter, preference, repeat process, screws, seams, shape, taillight assemblies, wheel, work tools
Any part that is modified and/or painted are non returnable.
1. Install steel weld-on light fillers (if applicable)
Measure and trace the housing shape to the area you plan to install them. Cut out the opening of the pattern using a plasma cutter, cutting wheel, or equivalent.
2. Insert the taillight bucket into opening and position as desired. Make sure to place the bucket as level as possible so the light reflects straight back from the vehicle. You can adjust the depth of the taillight bucket based on your preference. Stitch weld the bucket into place.
1. Install steel weld-on light fillers (if applicable)
Measure and trace the housing shape to the area you plan to install them. Cut out the opening of the pattern using a plasma cutter, cutting wheel, or equivalent.
2. Insert the taillight bucket into opening and position as desired. Make sure to place the bucket as level as possible so the light reflects straight back from the vehicle. You can adjust the depth of the taillight bucket based on your preference. Stitch weld the bucket into place.
Subscribe to:
Posts (Atom)
