This bulletin is being issued to revise the Steering Wheel Position Sensor or Steering Shaft Lower Bearing Replacement procedure in the Variable Effort Steering (1998-2001 model years) or Steering Wheel and Column (2002-2003 model years) and add the Steering Wheel Position Sensor Centering procedure in the Steering Wheel and Column sub-sections of the Service Manual. Please replace the current information in the Service Manual with the following information.
Showing posts with label sir system. Show all posts
Showing posts with label sir system. Show all posts
Friday, February 4, 2011
Revised Steering Wheel Position Sensor or Steering Shaft Lower Bearing
6:16 PM by onesecond
·
0
comments
Labels: PDF Download, shaft seal, SIR, sir system, spring retainers, Steering, variable effort, wheel position
Labels: PDF Download, shaft seal, SIR, sir system, spring retainers, Steering, variable effort, wheel position
Friday, January 28, 2011
1998 Chevrolet Truck Lock Cylinder Removal & Installation
2:07 AM by onesecond
·
0
comments
Labels: air bag deployment, bag, Chevrolet, inch lbs, module, negative battery cable, sir system, turn signal switch
Labels: air bag deployment, bag, Chevrolet, inch lbs, module, negative battery cable, sir system, turn signal switch
Removal Procedures:
1. Remove the steering wheel.
2. Remove the turn signal switch. It is not necessary to completely remove the switch from the column. Pull the switch rearward far enough to slip it over the end of the shaft, but do not pull the harness out of the column.
3. Turn the lock to Run.
1. Remove the steering wheel.
2. Remove the turn signal switch. It is not necessary to completely remove the switch from the column. Pull the switch rearward far enough to slip it over the end of the shaft, but do not pull the harness out of the column.
3. Turn the lock to Run.
Wednesday, January 26, 2011
GM Service Manuals SIR Disabling and Enabling Zone 2
5:54 PM by onesecond
·
0
comments
Labels: fuse, fuse block, GM, gm service manuals, impact sensor, panel source, SIR, sir system
Labels: fuse, fuse block, GM, gm service manuals, impact sensor, panel source, SIR, sir system
Disabling Procedure
Important: Refer to SIR Disabling and Enabling Zones on page 2-81 before disabling the SIR system.
1. Turn the steering wheel until the vehicle’s wheels are pointing straight ahead.
2. Turn OFF the ignition.
3. Remove the key from the ignition.
Important: With the SIR fuse removed and the ignition ON, the AIR BAG indicator illuminates. This is normal operation and does not indicate an SIR system malfunction.
Important: Refer to SIR Disabling and Enabling Zones on page 2-81 before disabling the SIR system.
1. Turn the steering wheel until the vehicle’s wheels are pointing straight ahead.
2. Turn OFF the ignition.
3. Remove the key from the ignition.
Important: With the SIR fuse removed and the ignition ON, the AIR BAG indicator illuminates. This is normal operation and does not indicate an SIR system malfunction.
Wednesday, January 19, 2011
2005 Chevrolet Venture Rocker Panel Replacement
1:18 AM by onesecond
·
0
comments
Labels: Chevrolet, chevrolet venture, lower quarter, negative battery cable, negative cable, panel, sir system, weld
Labels: Chevrolet, chevrolet venture, lower quarter, negative battery cable, negative cable, panel, sir system, weld
Removal Procedure
Refer to Approved Equipment for Collision Repair Caution in Cautions and Notices.
1. Disable the SIR system. Refer to SIR Disabling and Enabling Zones in SIR.
2. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnect/Connect Procedure in Engine Electrical.
Refer to Approved Equipment for Collision Repair Caution in Cautions and Notices.
1. Disable the SIR system. Refer to SIR Disabling and Enabling Zones in SIR.
2. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnect/Connect Procedure in Engine Electrical.
Wednesday, June 16, 2010
2000-2005 Cadillar Deville Inner Front Pillar, Center Pillar and Rear Wheelhouse Sectioning
11:35 PM by onesecond
·
0
comments
Labels: air bag, air bag deployment, Cadillac, caution, center pillar, extent, failure, hinge, horizontal line, integrity, mm 2, necessary components, PDF Download, personal injury, rocker panel, seams, sir system
Labels: air bag, air bag deployment, Cadillac, caution, center pillar, extent, failure, hinge, horizontal line, integrity, mm 2, necessary components, PDF Download, personal injury, rocker panel, seams, sir system
When performing service on or near the SIR components or the SIR wiring, the SIR system must be disabled. Failure to follow the correct procedure could cause air bag deployment, personal injury or unnecessary SIR system repairs. The full bodyside inner panel comes as a one piece assembly and can be replaced at factory seams after removal of outer panel, roof and glass. Any one of these procedures can be performed separately, or in any combination dependent upon the extent of damage to the vehicle.
Subscribe to:
Posts (Atom)
