When performing service on or near the SIR components or the SIR wiring, the SIR system must be disabled. Failure to follow the correct procedure could cause air bag deployment, personal injury or unnecessary SIR system repairs. The full bodyside inner panel comes as a one piece assembly and can be replaced at factory seams after removal of outer panel, roof and glass. Any one of these procedures can be performed separately, or in any combination dependent upon the extent of damage to the vehicle.
Showing posts with label hinge. Show all posts
Showing posts with label hinge. Show all posts
Wednesday, June 16, 2010
2000-2005 Cadillar Deville Inner Front Pillar, Center Pillar and Rear Wheelhouse Sectioning
11:35 PM by onesecond
·
0
comments
Labels: air bag, air bag deployment, Cadillac, caution, center pillar, extent, failure, hinge, horizontal line, integrity, mm 2, necessary components, PDF Download, personal injury, rocker panel, seams, sir system
Labels: air bag, air bag deployment, Cadillac, caution, center pillar, extent, failure, hinge, horizontal line, integrity, mm 2, necessary components, PDF Download, personal injury, rocker panel, seams, sir system
Friday, June 11, 2010
2010+ Kia Forte Koup QuickLIFT Installation Guide
2:36 AM by onesecond
·
0
comments
Labels: ball studs, brackets, center punch, drill bits, hammer, hinge, Kia, marker, masking tape, permanent marker, quicklift, rt, ruler, step 2, step 3, step source, tape measure
Labels: ball studs, brackets, center punch, drill bits, hammer, hinge, Kia, marker, masking tape, permanent marker, quicklift, rt, ruler, step 2, step 3, step source, tape measure
Step 1 - Unpack QuickLIFT system and verify contents. Remove all items from the packing tube. You should have the following before beginning: * (2) Gas springs (RT-QL-200-4A) - Be sure to cycle them a few times before installing. * (4) 3/16" multi-grip #1 rivets (used on hood brackets) * (2) ball-studs and washers * Printed Color Instructions
Tuesday, June 1, 2010
1996-2000 Honda Civic Vertical Door Installation
2:15 AM by onesecond
·
0
comments
Labels: 10mm, apron, blue painters tape, bolt, bolts, fender, hinge, hinges, Honda, honda civic, paint, screws, slack, spacer, vertical doors inc, wheel, wire harness
Labels: 10mm, apron, blue painters tape, bolt, bolts, fender, hinge, hinges, Honda, honda civic, paint, screws, slack, spacer, vertical doors inc, wheel, wire harness
1) Disconnect the battery. 2) Remove fender: Remove all Phillip’s screws from the wheel well. Remove (1) 12mm bolt to loosen the bumper. Once the 12mm bolt has been removed pull on the bumper and remove (2) 8mm bolts from behind the bumper. Remove (3) 8mm bolts form the top of the fender. Remove (2) 8mm bolts from the bottom of the fender by the door. Remove (1) 8mm bolt holding the fender. At this point you should be able to remove the fender. 3) Remove the door catch: Open the door and remove (1) 10mm bolt from the body and (2) 10mm from the door. Push the door catch inside the door. 4) Gaining wire slack: Remove foot trim, under it you will find (2) wire harness use the
Subscribe to:
Posts (Atom)
