INSTALLATION
1) Remove knee panel under steering column, then remove (6) 10mm screws to release steel panel.
2) Remove lower steering column cover and driver side kick panel.
3) Connect the Red Cruise Harness Wire to Pink 12v Ignition Vehicle Wire behind fuse.
4) Connect the Black Cruise Harness Wire to Black Wire/Position 87 of 4
Showing posts with label 10mm. Show all posts
Showing posts with label 10mm. Show all posts
Monday, January 3, 2011
06 Chevrolet Aveo/Wave Cruise Control Installation Instructions
3:32 AM by onesecond
·
0
comments
Labels: 10mm, 5mm, aveo, Chevrolet, chevrolet aveo, cruise control module, fuse, knee panel, lettering, metal bracket, pin connector, screws, shroud, side kick panel, steel panel, steering column, switch harness, tape measure, wire harness, yellow wires
Labels: 10mm, 5mm, aveo, Chevrolet, chevrolet aveo, cruise control module, fuse, knee panel, lettering, metal bracket, pin connector, screws, shroud, side kick panel, steel panel, steering column, switch harness, tape measure, wire harness, yellow wires
Tuesday, June 1, 2010
1996-2000 Honda Civic Vertical Door Installation
2:15 AM by onesecond
·
0
comments
Labels: 10mm, apron, blue painters tape, bolt, bolts, fender, hinge, hinges, Honda, honda civic, paint, screws, slack, spacer, vertical doors inc, wheel, wire harness
Labels: 10mm, apron, blue painters tape, bolt, bolts, fender, hinge, hinges, Honda, honda civic, paint, screws, slack, spacer, vertical doors inc, wheel, wire harness
1) Disconnect the battery. 2) Remove fender: Remove all Phillip’s screws from the wheel well. Remove (1) 12mm bolt to loosen the bumper. Once the 12mm bolt has been removed pull on the bumper and remove (2) 8mm bolts from behind the bumper. Remove (3) 8mm bolts form the top of the fender. Remove (2) 8mm bolts from the bottom of the fender by the door. Remove (1) 8mm bolt holding the fender. At this point you should be able to remove the fender. 3) Remove the door catch: Open the door and remove (1) 10mm bolt from the body and (2) 10mm from the door. Push the door catch inside the door. 4) Gaining wire slack: Remove foot trim, under it you will find (2) wire harness use the
Subscribe to:
Posts (Atom)
