INSTALLATION
1) Remove knee panel under steering column, then remove (6) 10mm screws to release steel panel.
2) Remove lower steering column cover and driver side kick panel.
3) Connect the Red Cruise Harness Wire to Pink 12v Ignition Vehicle Wire behind fuse.
4) Connect the Black Cruise Harness Wire to Black Wire/Position 87 of 4
Showing posts with label metal bracket. Show all posts
Showing posts with label metal bracket. Show all posts
Monday, January 3, 2011
06 Chevrolet Aveo/Wave Cruise Control Installation Instructions
3:32 AM by onesecond
·
0
comments
Labels: 10mm, 5mm, aveo, Chevrolet, chevrolet aveo, cruise control module, fuse, knee panel, lettering, metal bracket, pin connector, screws, shroud, side kick panel, steel panel, steering column, switch harness, tape measure, wire harness, yellow wires
Labels: 10mm, 5mm, aveo, Chevrolet, chevrolet aveo, cruise control module, fuse, knee panel, lettering, metal bracket, pin connector, screws, shroud, side kick panel, steel panel, steering column, switch harness, tape measure, wire harness, yellow wires
Sunday, October 3, 2010
1991-96 Ford Escort Baseplate BX2112 Installation Instructions
2:43 AM by onesecond
·
0
comments
Labels: base tube, baseplate, belly pan, bolts, brackets, car frame, Ford, ford escort, gap, metal bracket, nuts, plastic pieces, spacers, support beam, tabs, three pieces, tie down, tube assembly
Labels: base tube, baseplate, belly pan, bolts, brackets, car frame, Ford, ford escort, gap, metal bracket, nuts, plastic pieces, spacers, support beam, tabs, three pieces, tie down, tube assembly
Installation of this baseplate requires removing the plastic belly pan. The brackets attached to the vehicle's frame and the tie down brackets also need to be removed. They will be replaced with the baseplate's side mounts. The plastic around the tie down brackets will need to be trimmed.
1. Read the General Instruction Sheet included with this baseplate.
2. Under the front corners of the car there is a stamped metal bracket that protrudes down with a slot at the bottom. These are called the tie down brackets. The baseplate mounts to the outside of the tie down brackets and to the center engine support bolts, using ten bolts, eight of which are supplied with the baseplate.
1. Read the General Instruction Sheet included with this baseplate.
2. Under the front corners of the car there is a stamped metal bracket that protrudes down with a slot at the bottom. These are called the tie down brackets. The baseplate mounts to the outside of the tie down brackets and to the center engine support bolts, using ten bolts, eight of which are supplied with the baseplate.
Saturday, October 2, 2010
1991-1996 Ford Escort Radio Replacement
3:54 PM by onesecond
·
0
comments
Labels: 2 pieces, antenna cable, clothes, coat hangers, Ford, ford escort, ford radio, holes, metal bracket, photos, proper tool, radios, rubber plug, shape, wire harness
Labels: 2 pieces, antenna cable, clothes, coat hangers, Ford, ford escort, ford radio, holes, metal bracket, photos, proper tool, radios, rubber plug, shape, wire harness
STEP 1: The Ford radio is snapped into the vehicles dash. With the proper tool, known as Ford radio removal keys, the Ford radio can be pulled forward out of the dash. A clothes hanger can be used instead of actual Ford radio removal keys. Cut the clothes hanger and bend 2 pieces in the shape as shown in the photos above. For more information on how to remove the radio, see the diagram below.
Subscribe to:
Posts (Atom)
