Step 1 - Unpack QuickLIFT system and verify contents. Remove all items from the packing tube. You should have the following before beginning: * (2) Gas springs (RT-QL-200-4A) - Be sure to cycle them a few times before installing. * (4) 3/16" multi-grip #1 rivets (used on hood brackets) * (2) ball-studs and washers * Printed Color Instructions
Showing posts with label step source. Show all posts
Showing posts with label step source. Show all posts
Friday, June 11, 2010
2010+ Kia Forte Koup QuickLIFT Installation Guide
2:36 AM by onesecond
·
0
comments
Labels: ball studs, brackets, center punch, drill bits, hammer, hinge, Kia, marker, masking tape, permanent marker, quicklift, rt, ruler, step 2, step 3, step source, tape measure
Labels: ball studs, brackets, center punch, drill bits, hammer, hinge, Kia, marker, masking tape, permanent marker, quicklift, rt, ruler, step 2, step 3, step source, tape measure
Sunday, May 9, 2010
Chrysler 300C/SRT-8 Headlight Disassembly
3:34 AM by onesecond
·
0
comments
Labels: 300c srt 8, bulbs, caution light, Chrysler, chrysler 300c srt 8, cookie sheet, fingerprints, first test, gap, heating element, high beam, latex gloves, oven mitts, PDF Download, reflectors, shop towels, step source, timer, turn signal
Labels: 300c srt 8, bulbs, caution light, Chrysler, chrysler 300c srt 8, cookie sheet, fingerprints, first test, gap, heating element, high beam, latex gloves, oven mitts, PDF Download, reflectors, shop towels, step source, timer, turn signal
1) Remove the high beam bulb and turn signal bulbs, this allows the inside of the lamp to heat at the same rate as the outside of the lamp.
-First, test fit the headlight in the cool oven. The lamp should be situated in the center of the oven, away from the heating element. You can use a cookie sheet to shield the light from direct heat.
-Preheat the oven to 235 degrees, once pre-heated insert the lamp and set a timer for 20 Minutes.
-First, test fit the headlight in the cool oven. The lamp should be situated in the center of the oven, away from the heating element. You can use a cookie sheet to shield the light from direct heat.
-Preheat the oven to 235 degrees, once pre-heated insert the lamp and set a timer for 20 Minutes.
Subscribe to:
Posts (Atom)
