Part One: Rear bracket attachment
Step 1) Attach the rear brackets to the step as shown in Figure 1, using a washer, E, and nut, I, on each stud. Tighten each nut.
Step 2) Place the cross member in position as shown in Figure 2, and secure using washers D and F, and one nut, H on each stud. Leave fasteners loose, as the bracket slots will be used to determine exact fit of rear upright bracket.
Showing posts with label center punch. Show all posts
Showing posts with label center punch. Show all posts
Friday, January 14, 2011
Kodiak Installation Instructions
11:58 PM by onesecond
·
0
comments
Labels: angle brackets, bit, bolt hole, cap screws, center punch, PDF Download, Step, ups driver
Labels: angle brackets, bit, bolt hole, cap screws, center punch, PDF Download, Step, ups driver
Thursday, December 30, 2010
Chevrolet Silverado Rear Vision System Nav Display Installation Instructions
1:35 AM by onesecond
·
0
comments
Labels: bezel, bolts, center punch, Chevrolet, chevrolet silverado, figure 1, inset, lamps, latch handle, mounting bolt, negative battery cable, preparation 1, punch mark, rear vision system, retainer, sill plate, socket 6, step 8, template sheet, work surface
Labels: bezel, bolts, center punch, Chevrolet, chevrolet silverado, figure 1, inset, lamps, latch handle, mounting bolt, negative battery cable, preparation 1, punch mark, rear vision system, retainer, sill plate, socket 6, step 8, template sheet, work surface
Preparation
1. Ensure all lamps and accessories are OFF.
2. Ensure the ignition switch is in the OFF position.
3. Loosen the negative battery cable bolt. Remove negative battery cable from terminal and position away from battery.
4. Wait one (1) minute prior to working on the vehicle to assure SIR roof rail airbag system has been disabled for your safety.
1. Ensure all lamps and accessories are OFF.
2. Ensure the ignition switch is in the OFF position.
3. Loosen the negative battery cable bolt. Remove negative battery cable from terminal and position away from battery.
4. Wait one (1) minute prior to working on the vehicle to assure SIR roof rail airbag system has been disabled for your safety.
Friday, June 11, 2010
2010+ Kia Forte Koup QuickLIFT Installation Guide
2:36 AM by onesecond
·
0
comments
Labels: ball studs, brackets, center punch, drill bits, hammer, hinge, Kia, marker, masking tape, permanent marker, quicklift, rt, ruler, step 2, step 3, step source, tape measure
Labels: ball studs, brackets, center punch, drill bits, hammer, hinge, Kia, marker, masking tape, permanent marker, quicklift, rt, ruler, step 2, step 3, step source, tape measure
Step 1 - Unpack QuickLIFT system and verify contents. Remove all items from the packing tube. You should have the following before beginning: * (2) Gas springs (RT-QL-200-4A) - Be sure to cycle them a few times before installing. * (4) 3/16" multi-grip #1 rivets (used on hood brackets) * (2) ball-studs and washers * Printed Color Instructions
Subscribe to:
Posts (Atom)
