Chrysler 300C/SRT-8 Headlight Disassembly

1) Remove the high beam bulb and turn signal bulbs, this allows the inside of the lamp to heat at the same rate as the outside of the lamp.
-First, test fit the headlight in the cool oven. The lamp should be situated in the center of the oven, away from the heating element. You can use a cookie sheet to shield the light from direct heat.
-Preheat the oven to 235 degrees, once pre-heated insert the lamp and set a timer for 20 Minutes.

1999.5-2001 Audi A4 (B5) HID conversion installation instructions

1. Take the kit out of the box and lay everything out. You can install either the ballasts or bulbs first but typically it is easier to install the bulbs first.
2. There are 3 T27 torx screws holding the headlight on. The 2 on top are visible in this picture.
3. with the 2 screws removed.
4. The third screw is shown here. A long extension is needed to get to it and an extendable magnet is helpful to retrieve the screw (or bit if it falls).
5. Disconnect the headlight and turn signal connectors and remove the headlight by pulling it toward the outside of the car and toward you.