Guide for 1988 Mazda Truck B Series Truck L4-2184cc 2.2L 2200 Vehicle Level Engine, Cooling and Exhaust Engine Timing Belt Service and Repair Timing Belt Removal and Installation
1. Align the timing mark on the timing belt pulley and camshaft pulley with the marks.
2. Remove all the spark plugs.
NOTE: This is to prevent compression while rotating the timing belt.
3. This procedure must be used to install the timing belt.
Showing posts with label tension. Show all posts
Showing posts with label tension. Show all posts
Thursday, May 27, 2010
1988 Mazda Truck B Series Truck Timing Belt Removal and Installation
11:17 PM by onesecond
·
0
comments
Labels: arrow, bolt, camshaft, caution, crankshaft, crankshaft pulley, mazda, mazda truck, spark plugs, tension, timing belt pulley, timing belt tensioner
Labels: arrow, bolt, camshaft, caution, crankshaft, crankshaft pulley, mazda, mazda truck, spark plugs, tension, timing belt pulley, timing belt tensioner
Tuesday, May 25, 2010
1995 Porsche 911 Carrera Convertible Top Installation
12:02 AM by onesecond
·
0
comments
Labels: canvas, caps, contour, convertible tops, hinges, locks, nuts, Porsche, porsche 911, porsche 911 carrera, rear window, screws, shims, tension, top frame
Labels: canvas, caps, contour, convertible tops, hinges, locks, nuts, Porsche, porsche 911, porsche 911 carrera, rear window, screws, shims, tension, top frame
CONVERTIBLE TOP - POWER 1995 ACCESSORIES & EQUIPMENT Porsche Power Convertible Tops Removal
1. Remove screws on rear wall trim panel at bottom left and right sides. Push up and pull out rear wall trim panel. Remove caps on tensioning bar. 2. Remove tensioning bar and bracket. Open convertible top locks. Remove nuts and screws on top mounts and guide arm tensioning bar. Lift convertible top off of vehicle.
1. Remove screws on rear wall trim panel at bottom left and right sides. Push up and pull out rear wall trim panel. Remove caps on tensioning bar. 2. Remove tensioning bar and bracket. Open convertible top locks. Remove nuts and screws on top mounts and guide arm tensioning bar. Lift convertible top off of vehicle.
Monday, May 24, 2010
1984 Chevrolet Corvette Fuel Injection System
8:15 PM by onesecond
·
0
comments
Labels: body assembly, Chevrolet, chevrolet corvette, corvette fuel injection, fuel injection, fuel injection system, fuel injector, fuel meter, fuel pressure regulator, gasket, general motors, interchange, personal injury, regulator assembly, screwdriver, screws, tension, throttle body, throttle valve
Labels: body assembly, Chevrolet, chevrolet corvette, corvette fuel injection, fuel injection, fuel injection system, fuel injector, fuel meter, fuel pressure regulator, gasket, general motors, interchange, personal injury, regulator assembly, screwdriver, screws, tension, throttle body, throttle valve
FUEL INJECTION SYSTEM - DUAL UNIT TBI 1984 Fuel Injection GENERAL MOTORS ELECTRONIC - DUAL UNIT OVERHAUL DISASSEMBLY NOTE: Before performing any service on throttle body assembly, it is essential that throttle body be placed on a holding fixture (J-9789-118, BT 30-15 or equivalent) to prevent damage to throttle valve. Disassembly of each throttle body unit is the same. DO NOT interchange components between front and rear units.
Subscribe to:
Posts (Atom)
