This kit includes “push to connect” airline fittings. They require the end of the airline to be round, square and cleanly cut to ensure the internal seal will not leak. The airline must only be cut with a sharp razor knife or hose cutter.
PREASSEMBLY OF THE AIR SPRINGS THE UPPER PLATE
1. Place the upper roll plate (with the rounded side towards the air spring) on the top of the air spring (top being the end with the air port). Repeat on the other air spring.
2. Install the air fittings supplied into the inlet ports of the air springs, use thread sealant to prevent air leaks. The air spring ports will be installed towards the center of the vehicle. The passengers side fitting will point towards the front of the vehicle. Do not over tighten the fittings.
THE UPPER BRACKET
3. Place the drivers side upper mounting bracket on top of air spring aligning the two mounting holes as shown in the photo.
Note: The driver side bracket mounts to the air spring through the elongated holes on each side of the air inlet port cutout. The passenger side bracket mounts to the air spring through the elongated holes opposite the air inlet port cutout.
THE LOWER BRACKET
4 Install the clinch stud into the drivers side lower bracket hole, shown in the photo. This is an interference fit into the bracket. Clinch stud not required on the passengers side lower bracket. 2500 model only (3/4 ton trucks) require a 3/8" bolt and nut to be installed in both lower brackets as shown. The bolt head is installed opposite the air spring. The nut will fit inside the roll plate cavity. Tighten the nut securely.
Source
Showing posts with label bolt and nut. Show all posts
Showing posts with label bolt and nut. Show all posts
Wednesday, January 26, 2011
HP10005 Air Suspension Kit for GMC/Chevrolet 2500 HD/3500 2WD/4WD
5:06 PM by onesecond
·
0
comments
Labels: air suspension kit, airline fittings, bolt and nut, Chevrolet, chevrolet 2500 hd, GMC, interference fit, port, side
Labels: air suspension kit, airline fittings, bolt and nut, Chevrolet, chevrolet 2500 hd, GMC, interference fit, port, side
Tuesday, June 1, 2010
96-00 Honda Civil Door Panel Removal & Installation
2:12 AM by onesecond
·
0
comments
Labels: 6mm, assembly source, bolt and nut, civic del sol, door handle, electrical connector, Honda, honda civic, honda civic del sol, honda civil, integrity, interior door, lock switch, rear doors, removal tool, rivet, rivets, screw, screws, speaker grille
Labels: 6mm, assembly source, bolt and nut, civic del sol, door handle, electrical connector, Honda, honda civic, honda civic del sol, honda civil, integrity, interior door, lock switch, rear doors, removal tool, rivet, rivets, screw, screws, speaker grille
Remove the screw from behind the interior door handle Slide out the door handle trim as shown Removing the door panel from the passenger side door View of the inside of the door, panel removed 1. Remove the screw from the door handle trim. 2. Slide the handle assembly forward and out to access the lock rod clip. 3. Release the clip 4. Disconnect the door lock switch 5. Remove the door opener handle assembly. 6. Carefully pry at the small opening on the bottom of the speaker grill. 7. Remove the speaker grille. 8. Remove the speaker mounting screws. 9. Detach the electrical connector and remove the speaker. 10. Remove the screws in the armrest. 11. Remove the center from the trim clip at the upper front of the door panel and remove the clip. 12. Using a suitable trim panel removal tool, unsnap the door panel from the door frame. 13. Carefully lift the door panel up and away from the door frame. To install: 14. Installation is the reverse of the removal procedure.
Subscribe to:
Posts (Atom)
