Showing posts with label lock switch. Show all posts
Showing posts with label lock switch. Show all posts
Tuesday, June 22, 2010
2005-2006 Chrysler 300C Vehicle Wiring
2:28 AM by onesecond
·
0
comments
Labels: 2005 chrysler 300c, Chrysler, kick panel, light switch, lock switch, ohm resistor, pillar, starter wire, supervision, trunk release
Labels: 2005 chrysler 300c, Chrysler, kick panel, light switch, lock switch, ohm resistor, pillar, starter wire, supervision, trunk release
WIRING INFORMATION: 2005 Chrysler 300C WIRE WIRE COLOR WIRE LOCATION 12V CONSTANT WIRE Must go to battery for 12V constant. STARTER WIRE PINK/DK.GREEN Ignition Harness SECOND STARTER WIRE PURPLE/BROWN Ignition Harness The second starter wire is a negative trigger through a 180-ohm resistor. IGNITION WIRE PINK/WHITE Ignition Harness ACCESSORY WIRE PURPLE/BROWN Ignition Harness The accessory wire is the same wire as the second starter wire. The accessory wire is a negative trigger through a 610-ohm resistor. POWER DOOR LOCK AND UNLOCK PURPLE/DK.GREEN Harness In Driver’s Kick Panel Lock is a negative trigger through a 330-ohm resistor. Unlock is
Tuesday, June 1, 2010
96-00 Honda Civil Door Panel Removal & Installation
2:12 AM by onesecond
·
0
comments
Labels: 6mm, assembly source, bolt and nut, civic del sol, door handle, electrical connector, Honda, honda civic, honda civic del sol, honda civil, integrity, interior door, lock switch, rear doors, removal tool, rivet, rivets, screw, screws, speaker grille
Labels: 6mm, assembly source, bolt and nut, civic del sol, door handle, electrical connector, Honda, honda civic, honda civic del sol, honda civil, integrity, interior door, lock switch, rear doors, removal tool, rivet, rivets, screw, screws, speaker grille
Remove the screw from behind the interior door handle Slide out the door handle trim as shown Removing the door panel from the passenger side door View of the inside of the door, panel removed 1. Remove the screw from the door handle trim. 2. Slide the handle assembly forward and out to access the lock rod clip. 3. Release the clip 4. Disconnect the door lock switch 5. Remove the door opener handle assembly. 6. Carefully pry at the small opening on the bottom of the speaker grill. 7. Remove the speaker grille. 8. Remove the speaker mounting screws. 9. Detach the electrical connector and remove the speaker. 10. Remove the screws in the armrest. 11. Remove the center from the trim clip at the upper front of the door panel and remove the clip. 12. Using a suitable trim panel removal tool, unsnap the door panel from the door frame. 13. Carefully lift the door panel up and away from the door frame. To install: 14. Installation is the reverse of the removal procedure.
Subscribe to:
Posts (Atom)