03-06 Nissan 350Z Oil Cooler Installation Instructions

1. Install the small rubber o-rings supplied with the kit onto all the fittings that screw into the oil outlet and inlet ports (threaded). Every connection to the oil filter sandwich block will require a rubber o-ring gasket. Do not use any thread sealer or Teflon tape on any of the fittings to the oil filter, block, cooler, or cooler lines. If you are installing an oil

2003-Up Nissan 350Z Edelbrock Nitrous System

The Edelbrock Nissan 350Z Performer EFI Nitrous System (Part Number 71007) is designed for 2003-Later Nissan 350Z vehicles equipped with stock 3.5L engines that utilize the returnless style fuel system. Horsepower and torque increases can vary with equipment upgrades and modifications.

2003 Nissan 350z Driver's Seat Click Noise or Side to Side Movement When Turning

When tuning left or right,
• The driver’s seat makes a “click” noise, and/or
• The driver’s seat moves side to side (left or right),
ACTION:
• Install special washers between the seat thigh support adjuster and the sliding and reclining device—inner and outer (see Figure 1).
NOTE: This is the only authorized repair for this incident (i.e. click noise or side to side movement when turning).
SERVICE PROCEDURE
NOTE: Steps a, b and c below only apply to vehicles equipped with front side (SRS) air bags.
a. Write down all radio station presets.
b. Disconnect the negative battery cable.
c. Wait at least 3 minutes after the negative battery cable is disconnected before removing the driver’s seat.

03-06 Nissan 350z Test pipes with Built in mechanical O2 sensor fix

Before you begin, allow engine to cool down. Spray down all bolts & nuts with WD-40 (or similar) and allow it to soak into the threads. The nuts & bolts will seize themselves onto the threads and spaying them down with Liquid Wrench or similar will make it much easier to remove the nuts & bolts.
- Test pipes laid out & test pipes laid out w/ additional wide band O2 ports.
- Close up detail of mechanical O2 sensor fix
- Remove 3 14mm nuts at exhaust manifold/catalytic converter flange. There are three nuts holding the catalytic converter to the exhaust manifold. Two nuts are facing the ground on one side of the flange, the third nut is on the opposite side of the flange. Use a 14mm stubby wrench or “S” wrench to remove the third nut. Repeat for other side.

G35 Coupe Aluminum Pedal Install

I purchased the Infiniti aluminum pedal set from Grubbs Infiniti in Dallas over the phone from Danny our FX45 salesmen. I believe Danny said these pedals are the ones used in the FX45. After examining them, I think he's probably right because the dead pedal is narrower and sits up higher than either the standard G35 plastic dead pedal or the Nissan 350Z dead pedal. The brake and gas pedals look the same.
Parts
All of the parts in their respective plastic bags with part numbers. These are for the 5AT. For the 6MT the clutch and brake pedals are different. Total price ~$80 shipped.

350Z GT Aero Front Bumper Installation Manual

This product is meant to fit Nissan 350Z only. Please check the parts before mounting.
- Mounting Procedure
Please follow the manufacturer’s repair manual for proper front bumper cover removal procedure.
（Remove the side bracket from the OEM bumper. ）
(Remove the impact foam from the front of the bumper.）
Install the side bracket onto the GT bumper by reversing the steps used to remove it.
Install the GT bumper using the factory clips and screws to the original locations.