Before you begin, allow engine to cool down. Spray down all bolts & nuts with WD-40 (or similar) and allow it to soak into the threads. The nuts & bolts will seize themselves onto the threads and spaying them down with Liquid Wrench or similar will make it much easier to remove the nuts & bolts.
- Test pipes laid out & test pipes laid out w/ additional wide band O2 ports.
- Close up detail of mechanical O2 sensor fix
- Remove 3 14mm nuts at exhaust manifold/catalytic converter flange. There are three nuts holding the catalytic converter to the exhaust manifold. Two nuts are facing the ground on one side of the flange, the third nut is on the opposite side of the flange. Use a 14mm stubby wrench or “S” wrench to remove the third nut. Repeat for other side.
Showing posts with label wd 40. Show all posts
Showing posts with label wd 40. Show all posts
Thursday, October 21, 2010
03-06 Nissan 350z Test pipes with Built in mechanical O2 sensor fix
1:31 AM by onesecond
·
0
comments
Labels: catalytic converter, catalytic converters, exhaust manifold, flange, liquid wrench, Nissan, nissan 350z, nuts bolts, o2 sensor, oxygen sensor, ports, s wrench, sensors, stubby wrench, test pipes, threads, wd 40
Labels: catalytic converter, catalytic converters, exhaust manifold, flange, liquid wrench, Nissan, nissan 350z, nuts bolts, o2 sensor, oxygen sensor, ports, s wrench, sensors, stubby wrench, test pipes, threads, wd 40
Tuesday, May 25, 2010
Chrysler 300C 5.7L Hemi Engine Dynomax Kit 19412 Installation
5:01 AM by onesecond
·
0
comments
Labels: chassis, Chrysler, chrysler 300c, clamps, exhaust system, hangers, installation steps, instruction source, left hand, muffler, PDF Download, rubber isolators, system assembly, tail pipe, tail pipes, turbo mufflers, wd 40
Labels: chassis, Chrysler, chrysler 300c, clamps, exhaust system, hangers, installation steps, instruction source, left hand, muffler, PDF Download, rubber isolators, system assembly, tail pipe, tail pipes, turbo mufflers, wd 40
This dynomax kit for chrysler 300C 5.7L Hemi Engine installation steps:
1. Remove the old exhaust system assembly from the vehicle. Lubricate the rubber isolators with WD-40, or a similar product, to aid in removal of the metal rod hangers.
2. Install DynoMax front exhaust x-pipe 54320. Finger tighten the inlet clamps.
3. Install DynoMax Super Turbo Mufflers 17662, right hand and left hand. Finger tighten the 2ı⁄₂" clamps that connect the mufflers to the x-pipe.
1. Remove the old exhaust system assembly from the vehicle. Lubricate the rubber isolators with WD-40, or a similar product, to aid in removal of the metal rod hangers.
2. Install DynoMax front exhaust x-pipe 54320. Finger tighten the inlet clamps.
3. Install DynoMax Super Turbo Mufflers 17662, right hand and left hand. Finger tighten the 2ı⁄₂" clamps that connect the mufflers to the x-pipe.
Subscribe to:
Posts (Atom)
