Installation Sequences
After TMS and Safety mandated preparatory steps have been taken, the installation sequence is the suggested method for completing the accessory installation. In some instances the suggested sequence is written for one associate to install and in others the sequence is given as part of a team accessory installation. Unless otherwise stated in the document, the associates may perform the installation steps in any order to make the installation as efficient as possible while maintaining consistent quality. Section I – Installation Preparation Each kit will have 3 main brackets with plates & 2 support brackets per side of vehicle as shown.
Showing posts with label installation steps. Show all posts
Showing posts with label installation steps. Show all posts
Wednesday, June 2, 2010
2003 Toyota Tacoma Lighted Running Boards Instalation
2:45 AM by onesecond
·
0
comments
Labels: 2003 toyota tacoma, accessory installation, bolts, consistent quality, holes, installation sequence, installation steps, instances, nuts, preparatory steps, quality section, rear plates, running boards, sequences, support brackets, tms, Toyota, toyota tacoma
Labels: 2003 toyota tacoma, accessory installation, bolts, consistent quality, holes, installation sequence, installation steps, instances, nuts, preparatory steps, quality section, rear plates, running boards, sequences, support brackets, tms, Toyota, toyota tacoma
Tuesday, May 25, 2010
Chrysler 300C 5.7L Hemi Engine Dynomax Kit 19412 Installation
5:01 AM by onesecond
·
0
comments
Labels: chassis, Chrysler, chrysler 300c, clamps, exhaust system, hangers, installation steps, instruction source, left hand, muffler, PDF Download, rubber isolators, system assembly, tail pipe, tail pipes, turbo mufflers, wd 40
Labels: chassis, Chrysler, chrysler 300c, clamps, exhaust system, hangers, installation steps, instruction source, left hand, muffler, PDF Download, rubber isolators, system assembly, tail pipe, tail pipes, turbo mufflers, wd 40
This dynomax kit for chrysler 300C 5.7L Hemi Engine installation steps:
1. Remove the old exhaust system assembly from the vehicle. Lubricate the rubber isolators with WD-40, or a similar product, to aid in removal of the metal rod hangers.
2. Install DynoMax front exhaust x-pipe 54320. Finger tighten the inlet clamps.
3. Install DynoMax Super Turbo Mufflers 17662, right hand and left hand. Finger tighten the 2ı⁄₂" clamps that connect the mufflers to the x-pipe.
1. Remove the old exhaust system assembly from the vehicle. Lubricate the rubber isolators with WD-40, or a similar product, to aid in removal of the metal rod hangers.
2. Install DynoMax front exhaust x-pipe 54320. Finger tighten the inlet clamps.
3. Install DynoMax Super Turbo Mufflers 17662, right hand and left hand. Finger tighten the 2ı⁄₂" clamps that connect the mufflers to the x-pipe.
Subscribe to:
Posts (Atom)
