Installation Sequences
After TMS and Safety mandated preparatory steps have been taken, the installation sequence is the suggested method for completing the accessory installation. In some instances the suggested sequence is written for one associate to install and in others the sequence is given as part of a team accessory installation. Unless otherwise stated in the document, the associates may perform the installation steps in any order to make the installation as efficient as possible while maintaining consistent quality. Section I – Installation Preparation Each kit will have 3 main brackets with plates & 2 support brackets per side of vehicle as shown.
Showing posts with label support brackets. Show all posts
Showing posts with label support brackets. Show all posts
Wednesday, June 2, 2010
2003 Toyota Tacoma Lighted Running Boards Instalation
2:45 AM by onesecond
·
0
comments
Labels: 2003 toyota tacoma, accessory installation, bolts, consistent quality, holes, installation sequence, installation steps, instances, nuts, preparatory steps, quality section, rear plates, running boards, sequences, support brackets, tms, Toyota, toyota tacoma
Labels: 2003 toyota tacoma, accessory installation, bolts, consistent quality, holes, installation sequence, installation steps, instances, nuts, preparatory steps, quality section, rear plates, running boards, sequences, support brackets, tms, Toyota, toyota tacoma
Saturday, May 29, 2010
Chevy Big Block Long Water Pump Power Steering Bracket Installation
3:16 AM by onesecond
·
0
comments
Labels: assembly instructions, boss, castings, Chevrolet, chevy big block, chevy small block, hhcs, PDF Download, photos, power steering pump, pumps, spacer, spacers, stud, support bracket, support brackets, variations, water pump
Labels: assembly instructions, boss, castings, Chevrolet, chevy big block, chevy small block, hhcs, PDF Download, photos, power steering pump, pumps, spacer, spacers, stud, support bracket, support brackets, variations, water pump
Assembly Instructions (photos show Chevy small block kit but assembly is the same for big block)
1. Mount the (20151-A) Power Steering Bracket & water pump to engine block using two (S275) 3/8-16 x 4.1/4” SHCS & two (TP3-1.980) spacers (between (20151-A) Power Steering Bracket & water pump) (fig. 1).
2. If your power steering pump came equipped with a mounting stud at the rear of the pump, use an 11/16” wrench to remove the mounting stud from the pump unit (fig. 2)
1. Mount the (20151-A) Power Steering Bracket & water pump to engine block using two (S275) 3/8-16 x 4.1/4” SHCS & two (TP3-1.980) spacers (between (20151-A) Power Steering Bracket & water pump) (fig. 1).
2. If your power steering pump came equipped with a mounting stud at the rear of the pump, use an 11/16” wrench to remove the mounting stud from the pump unit (fig. 2)
Subscribe to:
Posts (Atom)
