Please read BOTH these Installation Instructions and the General Instructions before attempting to install or operate this equipment.
Many Blue Ox® Baseplates are designed to use existing holes and hardware to mount the baseplate to the towed vehicle. Even though bolts are there, do not assume they are adequate for baseplate mounting. Always use hardware supplied in the hardware kit and existing hardware specified in the Baseplate Installation Instructions.
Showing posts with label variations. Show all posts
Showing posts with label variations. Show all posts
Tuesday, November 9, 2010
2002-04 Honda CR-V BX2232 Baseplate Installation
3:43 AM by onesecond
·
0
comments
Labels: 10mm socket, auto manufacturer, baseplate, blue ox baseplates, bolt, end plates, fascia, hardware kit, holes, Honda, honda cr v, metric bolts, minor adjustments, push pins, pushpins, rangefinder, tabs, tolerances, tow bar, variations
Labels: 10mm socket, auto manufacturer, baseplate, blue ox baseplates, bolt, end plates, fascia, hardware kit, holes, Honda, honda cr v, metric bolts, minor adjustments, push pins, pushpins, rangefinder, tabs, tolerances, tow bar, variations
Saturday, May 29, 2010
Chevy Big Block Long Water Pump Power Steering Bracket Installation
3:16 AM by onesecond
·
0
comments
Labels: assembly instructions, boss, castings, Chevrolet, chevy big block, chevy small block, hhcs, PDF Download, photos, power steering pump, pumps, spacer, spacers, stud, support bracket, support brackets, variations, water pump
Labels: assembly instructions, boss, castings, Chevrolet, chevy big block, chevy small block, hhcs, PDF Download, photos, power steering pump, pumps, spacer, spacers, stud, support bracket, support brackets, variations, water pump
Assembly Instructions (photos show Chevy small block kit but assembly is the same for big block)
1. Mount the (20151-A) Power Steering Bracket & water pump to engine block using two (S275) 3/8-16 x 4.1/4” SHCS & two (TP3-1.980) spacers (between (20151-A) Power Steering Bracket & water pump) (fig. 1).
2. If your power steering pump came equipped with a mounting stud at the rear of the pump, use an 11/16” wrench to remove the mounting stud from the pump unit (fig. 2)
1. Mount the (20151-A) Power Steering Bracket & water pump to engine block using two (S275) 3/8-16 x 4.1/4” SHCS & two (TP3-1.980) spacers (between (20151-A) Power Steering Bracket & water pump) (fig. 1).
2. If your power steering pump came equipped with a mounting stud at the rear of the pump, use an 11/16” wrench to remove the mounting stud from the pump unit (fig. 2)
Subscribe to:
Posts (Atom)
