Procedure installing the Grill to Honda CRV
1. Remove the plastic rivets securing the plastic guard located underneath the vehicle in order to install the front bar.
2. Start with the passenger side assembly, postion one of the 7/16 nut plates behind the cross member opening and align the 7/16 nut plate wit the two matching holes in the frame rail. Fasten the frame brackets to the bottom cross member as shown in the illustration using the 7/16 x 1 ¼ hex bolts, 7/16 washers, 5/16 self tapping bolt and 5/16 washers. Note: Do not over tighten 5/16 x 1 self tapping bolt as it might strip threads.
Showing posts with label utility knife. Show all posts
Showing posts with label utility knife. Show all posts
Sunday, November 14, 2010
2005-06 HONDA CRV Grill/ Brush Guard Part #6049
1:39 AM by onesecond
·
0
comments
Labels: bolt, brackets, brush guard, cross member, fasteners, frame rail, hex bolts, hex nuts, holes, Honda, honda crv, illustration, inner edge, screw, screws, slots, support bracket, tapping, utility knife, wit
Labels: bolt, brackets, brush guard, cross member, fasteners, frame rail, hex bolts, hex nuts, holes, Honda, honda crv, illustration, inner edge, screw, screws, slots, support bracket, tapping, utility knife, wit
Thursday, May 6, 2010
Chrysler Pasifica DVD Rear Seat Video System Installation
3:31 AM by onesecond
·
0
comments
Labels: access panel, bezel, Chrysler, chrysler pasifica, component removal, cubby, dotted lines, masking tape, metal trim, negative battery cable, phillips screw, phillips screws, pillar, radio four, rear seat, t20, template instructions, tie straps, utility knife, video system
Labels: access panel, bezel, Chrysler, chrysler pasifica, component removal, cubby, dotted lines, masking tape, metal trim, negative battery cable, phillips screw, phillips screws, pillar, radio four, rear seat, t20, template instructions, tie straps, utility knife, video system
A – Interior Trim Panel and Component Removal:
1) Disconnect and isolate negative battery cable.
2) Detach the center console shift bezel.
3) Remove ignition key bezel.
4) Remove left and right I/P center bezels using a non-metal trim stick.
5) Disconnect and remove the CD/DVD player or cubby bin (four phillips screws).
6) Disconnect and remove the radio (four phillips screws).
1) Disconnect and isolate negative battery cable.
2) Detach the center console shift bezel.
3) Remove ignition key bezel.
4) Remove left and right I/P center bezels using a non-metal trim stick.
5) Disconnect and remove the CD/DVD player or cubby bin (four phillips screws).
6) Disconnect and remove the radio (four phillips screws).
Subscribe to:
Posts (Atom)
