1.) Rear Leaf Springs: We strongly recommend that you increase the number of leafs in the rear main springs before you begin the installation process. In most cases we have found that these additional leafs (Dodge - 4 leafs, Chev. - 3 leafs and Ford - 2 leafs), in addition to an in-cab controlled airbag system, will be adequate in most cases. The use of an airbag system has always proven to be far more effective than additional helper/overload springs.
Showing posts with label rear bumper. Show all posts
Showing posts with label rear bumper. Show all posts
Friday, December 10, 2010
Hy-Tech Wheel-Lift Installation (Pickup)
2:51 PM by onesecond
·
0
comments
Labels: airbag system, desire, Dodge, dodge trucks, Ford, frame damage, frame rails, hoses, leafs, overload springs, PDF Download, rear bumper, rear shock, reinforcement, shock mount, spare tire, wheel
Labels: airbag system, desire, Dodge, dodge trucks, Ford, frame damage, frame rails, hoses, leafs, overload springs, PDF Download, rear bumper, rear shock, reinforcement, shock mount, spare tire, wheel
Saturday, June 26, 2010
2004-05 Chevy Colorado Prerunner Rear Bumper Installation
11:38 PM by onesecond
·
0
comments
Labels: bolts, brackets, Chevrolet, chevy colorado, harness connector, license plate light, mechanical condition, original equipment, PDF Download, plastic tabs, rear bumper, stock, tow wire, trailer tow, wire harness
Labels: bolts, brackets, Chevrolet, chevy colorado, harness connector, license plate light, mechanical condition, original equipment, PDF Download, plastic tabs, rear bumper, stock, tow wire, trailer tow, wire harness
This kit should only be installed on a vehicle that is in good mechanical condition. Before installing the kit, replace worn or corroded parts. If the vehicle is suspected to have been in a collision or abused, DO NOT install the kit. The components in this kit do not eliminate weaknesses that may exist in the original equipment components.
Saturday, May 29, 2010
1993 Taurus/Sable Bumpers Removal and Installation
11:04 PM by onesecond
·
0
comments
Labels: 5b, bumpers, excessive heat, exhaust fumes, Ford, front bumper, illustrations, installation procedures, isolator, lb ft, rear bumper, req, rivet, sable, screw, surface heat, tail pipe, taurus
Labels: 5b, bumpers, excessive heat, exhaust fumes, Ford, front bumper, illustrations, installation procedures, isolator, lb ft, rear bumper, req, rivet, sable, screw, surface heat, tail pipe, taurus
Bumpers Refer to the following illustrations when performing Removal and Installation procedures on the front and rear bumper assemblies. CAUTION: Never apply excessive heat to bumper surface. Heat could cause distortion of the bumper. CAUTION: When collecting exhaust fumes in service area, never attach a metal collector to the exhaust tail pipe because the heat could damage the bumper.
Subscribe to:
Posts (Atom)
