This kit should only be installed on a vehicle that is in good mechanical condition. Before installing the kit, replace worn or corroded parts. If the vehicle is suspected to have been in a collision or abused, DO NOT install the kit. The components in this kit do not eliminate weaknesses that may exist in the original equipment components.
Showing posts with label chevy colorado. Show all posts
Showing posts with label chevy colorado. Show all posts
Saturday, June 26, 2010
2004-05 Chevy Colorado Prerunner Rear Bumper Installation
11:38 PM by onesecond
·
0
comments
Labels: bolts, brackets, Chevrolet, chevy colorado, harness connector, license plate light, mechanical condition, original equipment, PDF Download, plastic tabs, rear bumper, stock, tow wire, trailer tow, wire harness
Labels: bolts, brackets, Chevrolet, chevy colorado, harness connector, license plate light, mechanical condition, original equipment, PDF Download, plastic tabs, rear bumper, stock, tow wire, trailer tow, wire harness
Monday, June 21, 2010
2004-2006 Chevy Colorado Brute Force Intake System Installation
10:23 PM by onesecond
·
0
comments
Labels: battery c, battery terminal, bolts, brute force intake, Chevrolet, chevy colorado, hose adapter, hose clamp, level surface, line source, mass air flow, PDF Download, screws, stock air, stock intake, throttle body, wire harness
Labels: battery c, battery terminal, bolts, brute force intake, Chevrolet, chevy colorado, hose adapter, hose clamp, level surface, line source, mass air flow, PDF Download, screws, stock air, stock intake, throttle body, wire harness
Getting Started
a) Make sure vehicle is parked on a level surface. Set parking brake.
b) Disconnect negative battery terminal from the battery.
c) If engine has run within the past two hours, let it cool down.
Removal of the stock intake system.
a) Before removing any of the O.E. components, label each individual part so that no components become mixed up during the installation process.
a) Make sure vehicle is parked on a level surface. Set parking brake.
b) Disconnect negative battery terminal from the battery.
c) If engine has run within the past two hours, let it cool down.
Removal of the stock intake system.
a) Before removing any of the O.E. components, label each individual part so that no components become mixed up during the installation process.
Subscribe to:
Posts (Atom)
