2002-05 Cadillac Escalade Front Bar Part # 4049 Installation Instructions

Installing the mounting frame brackets
1. Remove factory tow hooks from front section of vehicle
2. Align driver side mounting bracket to the bottom and outer edge existing holes. Position bracket in manner shown below.
3. Attach mounting frame brackets using the 7/16 x 1 ― hex bolts, 7/16 hex nuts and 7/16 washers. (hand tighten as you may have to move the brackets around slightly, to align the front bar)
NOTE: 2WD models, you may have to cut a space in the plastic spoiler for the bottom of the front bar up rights to slide through and eventually attach to the frame mounting brackets.

2002 Cadillac Escalade Front Bar Part #4049 A Installation Instructions

INSTALLING THE MOUTNING FRAME BRACKETS
1. Remove factory tow hooks from front section of vehicle
2. align driver side mounting bracket to the bottom and outer edge existing holes. Position bracket in manner shown below. See figure 1.1
3. attach mounting frame brackets using the 7/16 x 1 ― hex bolts, 7/16 hex nuts and 7/16 washers. (hand tighten as you may have to move the brackets around slightly, to align the front bar)
NOTE: (2WD MODELS YOU MAY HAVE TO CUT A SPACE IN THE PLASTIC SPOILER FOR THE BOTTOM OF THE FRONT BAR UP RIGHTS TO SLIDE THROUGH AND EVENTUALLLY ATTACH TO THE FRAME MOUNTING BRACKETS.

1958-64 Chevy Rear End Kit Installation Instructions

INSTALLING THE FORWARD 4-LINK MOUNTING BRACKET:
1. The stock‘58-64 Chevy forward control-arm brackets will need to be trimmed to accept the new fabricat- ed forward 4-link control-arm brackets in your kit.
2. Looking at the front of the factory control- arm bracket, you’ll need to remove the material as shown. Keep the outside edge of the bracket (pen pointing to this edge) vertically straight. The new bracket seats against this edge on both sides of chassis.
3. Install the new bracket all the way into the stock frame bracket pocket until it seats on the outer edge. Keep the new bracket to the top edge of pocket