2005 Honda CR-V Door Visors P/N 08R04-S9A-101

Installation Door Visors on Honda CR-V 2005:
NOTE: • These instructions show the left door visors being installed. The same procedure applies to installing of the right door visors.
• Be careful not to damage the paint finish or glass run channels when installing the door visors.
• Handle the door visors with care. They are not designed to absorb shock or impact.
• This door visor kit should be installed only if the ambient air temperature is 60°F (15°C) or above.
• To allow the adhesive to cure, do not wash the vehicle for 24 hours.

2008 Toyota Highlander EC Rearview Mirror

Steps for EC Rearview Mirror installation: 1. Remove Battery Cable. (a) Protect fender before starting. (b) Do not touch the positive terminal with any tool when removing cable. (c) Remove the negative battery cable. (Fig. 1-1) 2. Vehicle Disassembly. (a) Remove the OE mirror. (1) Disengage the two claws and remove the mirror cover from the mirror base. (Fig. 2-1) (2) Pull the lever in the direction indicated by the arrow shown in the illustration and slide the inner rear view mirror assembly upward to remove it. (Fig. 2-1) (b) Using panel removal tool remove overhead console from headliner. (Fig. 2-2) (1) Disconnect any connectors connected to the overhead console. 3. Install T-taps. (a) Locate the disconnected 22-pin overhead console connector. (Fig. 3-1) (b) Peel back or cut approximately one inch of the wire cover. (Fig. 3-2) (c)