The AD37 is a small portable device that can read the pin codes from GM/Opel vehicles typically up to year 2000 models. The system consists of an immobiliser which is an integral part of the antenna/coil that is mounted around the ignition barrel.
SYSTEM IDENTIFICATION As a general rule the pin code can be read from all models up to year 2000 vehicles fitted with a white resistor on the immobiliser electronic circuit board. To identify the correct system, the immobiliser unit has to be removed and inspected (Refer to page 7).
Showing posts with label option 1. Show all posts
Showing posts with label option 1. Show all posts
Monday, June 7, 2010
AD37 GM/Opel Pin Code Reader Operating Manual
9:02 PM by onesecond
·
0
comments
Labels: antenna, cd 1, computer desktop, double click, electronic circuit board, GM, immobiliser, models, opel, option 1, pc option, pin code, resistor, software installation, usb connector, usb port, year 2000
Labels: antenna, cd 1, computer desktop, double click, electronic circuit board, GM, immobiliser, models, opel, option 1, pc option, pin code, resistor, software installation, usb connector, usb port, year 2000
Friday, June 4, 2010
55-59 Chevy Truck Kobi Rear Cab Cover Installation
5:19 AM by onesecond
·
0
comments
Labels: backside, Chevrolet, chevy truck, corner pieces, correct option, edge tape, flat surface, foam tape, glue dries, holes, installation test, option 1, PDF Download, pipe glue, retainer, top edge, weights
Labels: backside, Chevrolet, chevy truck, corner pieces, correct option, edge tape, flat surface, foam tape, glue dries, holes, installation test, option 1, PDF Download, pipe glue, retainer, top edge, weights
Test each corner for fit to ensure that the corners are correct.
Option #1: If covering each piece separately:
A) Start by applying the foam edge tape to corner pieces by running it along the entire edge of the panel stopping at both the top and the bottom where the edge of the panel meets the step where the corner pieces are fitted and fixed into the center section. Apply foam tape along the edge of entire center section, keeping the same idea to stop short of the sides that contain the mounted retainer strips that corner pieces will be mounted on.
Option #1: If covering each piece separately:
A) Start by applying the foam edge tape to corner pieces by running it along the entire edge of the panel stopping at both the top and the bottom where the edge of the panel meets the step where the corner pieces are fitted and fixed into the center section. Apply foam tape along the edge of entire center section, keeping the same idea to stop short of the sides that contain the mounted retainer strips that corner pieces will be mounted on.
Subscribe to:
Posts (Atom)
