U-Cut-To-Fit Speedometer Cable Kit Installation
Step 1: Install outer housing to speedometer and route housing to transmission, making sure to keep away from exhaust pipes.
Step 2: Hold housing up to transmission to determine length and mark a cut line. Remove housing from vehicle and cut housing at the cut line.
Step 3: After cutting housing, install end of housing into GM or Chrysler trans end fitting. Figure 1 Slide housing nut up and tighten until housing is locked into fitting.
Note: Do Not over tighten nut as it will result in fitting failure.
Showing posts with label step 6. Show all posts
Showing posts with label step 6. Show all posts
Friday, May 14, 2010
U-Cut-To-Fit GM & Chrysler Speedometer Cable Kit Installation Instructions
3:47 AM by onesecond
·
0
comments
Labels: bottoms, cable kit, car source, Chrysler, debur, exhaust pipes, failure, figure 1, GM, grease, hammer, PDF Download, pliers, screw, solid surface, speedometer cable, step 2, step 6, step 8, transmission gear
Labels: bottoms, cable kit, car source, Chrysler, debur, exhaust pipes, failure, figure 1, GM, grease, hammer, PDF Download, pliers, screw, solid surface, speedometer cable, step 2, step 6, step 8, transmission gear
Subscribe to:
Posts (Atom)
