INSTALLING THE GMOS-06
1)With all connections completed to the aftermarket radio, plug the 32 pin harness into the Cadillac’s wiring harness.
*Note: some minor modifications may be necessary to the sub dash cavity to accommodate the GMOS-06.
2) Cycle the key by turning the ignition on then back off, then on again to test the radio.
Showing posts with label connect one. Show all posts
Showing posts with label connect one. Show all posts
Sunday, June 27, 2010
Onstar GMOS06 Installation Instructions
12:01 AM by onesecond
·
0
comments
Labels: aftermarket radio, balance control, Cadillac, cavity, connect one, onstar, PDF Download, pin harness, speakers, volume level, volume settings, wiring harness, yellow wire
Labels: aftermarket radio, balance control, Cadillac, cavity, connect one, onstar, PDF Download, pin harness, speakers, volume level, volume settings, wiring harness, yellow wire
Wednesday, May 5, 2010
Water/Methanol Injection System for Chevy Cobalt SS/Iion Redline and All Ecotech Engines
11:47 PM by onesecond
·
0
comments
Labels: chassis, Chevrolet, chevy cobalt, chevy cobalt ss, connect one, ecotech engines, fluid reservoir, ground location, improper operation, location source, nozzle, PDF Download, ports, power source, redline, reservoirs, secure connection, solenoid, throttle plate, water methanol injection
Labels: chassis, Chevrolet, chevy cobalt, chevy cobalt ss, connect one, ecotech engines, fluid reservoir, ground location, improper operation, location source, nozzle, PDF Download, ports, power source, redline, reservoirs, secure connection, solenoid, throttle plate, water methanol injection
Solenoid Upgrade (optional)
The optional Solenoid Upgrade (#40060) is required if the nozzle is to be installed after the intake throttle plate (as shown), or the fluid reservoir is mounted higher then the nozzle. It is highly recommended for trunk-mount reservoirs.
Finger thread the two 1/8” NPT quick connect fittings into ports labeled IN and OUT on the solenoid. Tighten an additional half turn past finger tight.
The optional Solenoid Upgrade (#40060) is required if the nozzle is to be installed after the intake throttle plate (as shown), or the fluid reservoir is mounted higher then the nozzle. It is highly recommended for trunk-mount reservoirs.
Finger thread the two 1/8” NPT quick connect fittings into ports labeled IN and OUT on the solenoid. Tighten an additional half turn past finger tight.
Subscribe to:
Posts (Atom)
