Audi A6 C5 Service Reset

Service Reminder Indicator (SRI), resetting
The Service Reminder Indicator (SRI) must be reset during the pre-delivery inspection and after each oil change service or inspection service.
Pre-delivery inspection
The Service Reminder Indicator (SRI) can be reset in two different ways.
Using the VAG 1551 or VAG 1552 scan tool:
- Select adaptation channel 2 and input adaptation value "00000" or Using buttons on the instrument cluster:
- Reset "Service OIL" and "Service INSP"

Manual Service Reset Volvo 240 (1986 - 1989)

Reach behind the instrument panel and push the lever located between the tachometer and the speedometer. Volvo 240 (1990 - 1993) 1. Remove the plug from the face of the instrument panel between the clock and the speedometer. 2. Insert a thin-bladed tool into the cavity and press the reset button.
Volvo 850 (1993 - 1995) fitted with the Yazaki instrument panel
NOTE: This instrument panel has the odometer located above the speedometer needle. OM1033 1. Remove the plug from the face of the instrument panel between the clock and the speedometer. 2. Insert a thin-bladed tool into the cavity and press the reset button.
Volvo 850 (1993 - 1995) fitted with the VDO instrument panel
NOTE: This instrument panel has the odometer located below the speedometer needle. 1. With the ignition switch in the ON position and the engine not running. Diagnostic module located in engine compartment adjacent to LH suspension mount 2. Connect the diagnostic module test lead to terminal 7. 3. Press the reset button on the diagnostic module 4 times in quick succession. 4. When the LED on the diagnostic unit illuminates and stays illuminated, press the reset button once and release it. 5. When the LED illuminates and stays illuminated, press the button 5 times in quick succession. 6. When the LED illuminates again, press the button once. 7. The LED will flash several times to indicate that the sequence has been correctly entered and the SRI has been reset. 8. Unplug the test lead from terminal 7 and turn the ignition switch to the ‘OFF’ position.

Source

2005+ Toyota Tacoma Service Guide & Vehicle History

Remote Keyless Entry Reprogramming The vehicle should meet the following conditions before proceeding; *The key is NOT in the ignition *Driver’s door is OPEN (The others are CLOSED) *Drivers door UNLOCKED 1) INSERT & REMOVE key from ignition cylinder TWICE within 5sec 2) CLOSE and OPEN the driver’s door TWICE within 40sec 3) INSERT and REMOVE the key into the ignition cylinder 4) CLOSE and OPEN the driver’s door TWICE within 40 seconds 5) INSERT the key in the ignition and CLOSE the driver’s door 6) Turn the ignition switch from LOCK to ON and back to LOCK at 1sec Intervals "2" times to enter REWRITE MODE 7) REMOVE the key from the ignition (The door locks are cycled

1995 Volvo 850 Volvo Maintenance Reminder Light Reset Procedures

The Service Reminder Indicator (SRI) is triggered at the appropriate interval since last service. Depending on model, this is based on accumulated mileage, calendar time, or hours of engine operation. Once triggered, the SRI comes on each time the engine is started. The light goes out after approximately two minutes except on 850 Base variant (without trip computer). After service is performed and the SRI counter reset, the SRI will not light again until shortly before next service is due.