The TAG is intended to be used with the silencer ring in place. On 94-2002 Dodge trucks install the longer side into the turbo housing and the shorter side will be facing the inside of the intake boot. Remove the rubber boot from the turbo charger inlet and insert the TAG into the rubber boot with the longest part of the TAG facing outward as shown. The TAG should snap into the groove inside the boot. Place the supplied band clamp over the hose as shown in the photo below. Slip the boot back over the turbo inlet using one hand through the boot to guide the TAG into the turbo.
Showing posts with label groove. Show all posts
Showing posts with label groove. Show all posts
Tuesday, December 7, 2010
94-2002 Dodge Turbo Air Guide (TAG & TAG-II) Install
6:51 AM by onesecond
·
0
comments
Labels: air inlet, clamp, clamps, Dodge, dodge trucks, gap, groove, Other, photo, rubber boot, snug, tag tag, turbo air, turbo charger, turbo note
Labels: air inlet, clamp, clamps, Dodge, dodge trucks, gap, groove, Other, photo, rubber boot, snug, tag tag, turbo air, turbo charger, turbo note
Monday, May 17, 2010
Front Connected 63 Fuse Fitting
12:47 AM by onesecond
·
0
comments
Labels: conductor, conductors, copper, diameter, ferrule, ferrules, flexible cables, fuse, groove, PDF Download, red nylon, screw, strands, terminal c, thin wall, wall thickness
Labels: conductor, conductors, copper, diameter, ferrule, ferrules, flexible cables, fuse, groove, PDF Download, red nylon, screw, strands, terminal c, thin wall, wall thickness
Method of Cabling Front connected fuse fittings
1. Remove red nylon insulating shroud to release cable sleeve.
2. Remove cable sleeve.
3. Fit cable sleeve over cable.
4. Fit conductor into fuse base terminal and tighten cable clamping screw to secure. If flexible cables are used, their relatively fine strands may be given increased protection by the use of thin wall copper ferrules over the conductor.
The following should be taken into account:
1. Remove red nylon insulating shroud to release cable sleeve.
2. Remove cable sleeve.
3. Fit cable sleeve over cable.
4. Fit conductor into fuse base terminal and tighten cable clamping screw to secure. If flexible cables are used, their relatively fine strands may be given increased protection by the use of thin wall copper ferrules over the conductor.
The following should be taken into account:
Subscribe to:
Posts (Atom)
