Remove or Disconnect
Tool Required:
J 9886-01 Door Handle Clip Remover
1. Window regulator handle using J 9886-01.
2. Window regulator handle bezel.
3. Door control assembly handle using J 9886-01.
4. Control assembly handle bezel.
5. Assist strap (if equipped).
6. Arm rest (if equipped).
7. Door trim outer panel screws (if equipped).
Showing posts with label window regulator. Show all posts
Showing posts with label window regulator. Show all posts
Saturday, May 15, 2010
1992 Chevy Truck G 10 Van V8-305 5.0L Door Trim Panel Service Repair
8:14 AM by onesecond
·
2
comments
Labels: arm rest, bezel, Chevrolet, chevy truck, door handle, inner panel, outer panel, retainer, screws, v8, window regulator
Labels: arm rest, bezel, Chevrolet, chevy truck, door handle, inner panel, outer panel, retainer, screws, v8, window regulator
Friday, May 14, 2010
2001 GMC Truck C 1500 Truck 2WD Front Side Door Window Regulator Motor Replacement
11:38 PM by onesecond
·
0
comments
Labels: attachment point, bench, bolts, fastener, fasteners, fingers, gear teeth, GMC, gmc truck, motor replacement, screws, slides, window regulator
Labels: attachment point, bench, bolts, fastener, fasteners, fingers, gear teeth, GMC, gmc truck, motor replacement, screws, slides, window regulator
Removal Procedure
1. Raise the window. If the window motor is inoperable, remove the window to gain access to the window motor retaining screws. Refer to Front Side Door Window Replacement.
2. Remove the power window module.
3. With the window regulator on the bench, remove fasteners one (1) and two (2) which will disconnect the drive housing and motor (4) from the rail (5) motor slides out of the gear/spool, hold the gear/spool into the housing with your fingers. The spool will unwind if it comes out of the housing.
4. Holding the motor and housing together, remove fastener three (3).
5. Slide the motor partially out of the gear/spool allowing finger access to the gear spool (6). Hold the gear/spool into the housing and remove the motor (7).
1. Raise the window. If the window motor is inoperable, remove the window to gain access to the window motor retaining screws. Refer to Front Side Door Window Replacement.
2. Remove the power window module.
3. With the window regulator on the bench, remove fasteners one (1) and two (2) which will disconnect the drive housing and motor (4) from the rail (5) motor slides out of the gear/spool, hold the gear/spool into the housing with your fingers. The spool will unwind if it comes out of the housing.
4. Holding the motor and housing together, remove fastener three (3).
5. Slide the motor partially out of the gear/spool allowing finger access to the gear spool (6). Hold the gear/spool into the housing and remove the motor (7).
Subscribe to:
Posts (Atom)
