All 2004 vehicles that are considered LEV2 and SULEV with engine test group numbers of families do not satisfy or meet the California air resource board tet procedures. The engine group test numbers can be found on the underhood information label located on the drivers side. Engine test group numbers listed below are to be considered for off-road use only: 2004 Nissan Alima 2.5L test group number- 4NSXV02.585A
Showing posts with label sensor. Show all posts
Showing posts with label sensor. Show all posts
Monday, February 28, 2011
2002-04 Nissan Altima Dyno-Proven Cold Air Intake System Installation
2:58 AM by onesecond
·
0
comments
Labels: air intake system, california air resource board, cold air intake, cold air intake system, mass, Nissan, nissan altima, sensor
Labels: air intake system, california air resource board, cold air intake, cold air intake system, mass, Nissan, nissan altima, sensor
Tuesday, February 22, 2011
2001 Chevrolet Impala V6-3.8L Oil Pan Replacement
2:48 AM by onesecond
·
0
comments
Labels: Chevrolet, chevrolet impala, intake air temperature, negative battery cable, Oil, pipe brackets, sensor, support fixture
Labels: Chevrolet, chevrolet impala, intake air temperature, negative battery cable, Oil, pipe brackets, sensor, support fixture
Removal Procedure
1. Disconnect the negative battery cable.
2. Remove the fuel injector sight shield.
3. Disconnect the intake air temperature (IAT) sensor electrical connector.
4. Remove the air inlet duct from the throttle body.
5. Remove the drive belt.
1. Disconnect the negative battery cable.
2. Remove the fuel injector sight shield.
3. Disconnect the intake air temperature (IAT) sensor electrical connector.
4. Remove the air inlet duct from the throttle body.
5. Remove the drive belt.
Wednesday, February 16, 2011
58 mm LT1 NOS Throttle Body for the 1994-97 Chevrolet
9:37 PM by onesecond
·
0
comments
Labels: Chevrolet, head screws, installation failure, position, sensor, throttle position sensor, torx screws, vacuum lines
Labels: Chevrolet, head screws, installation failure, position, sensor, throttle position sensor, torx screws, vacuum lines
These instructions must be read and fully understood before beginning installation. Failure to follow these instructions may result in poor performance, vehicle damage, personal injury, or death. If these instructions are not fully understood, installation should not be attempted.
Subscribe to:
Posts (Atom)
