Old Distributor Removal:
Step 1-Disconnect the coil trigger wire coming from the distributor to the negative (-) side of the ignition coil at the coil terminal. Disconnect the wire supplying current to the positive side (+) of the ignition coil. There may be two wires on this terminal, one from the ballast resistor and one from the starter solenoid. The ballast resistor should have one wire left, the
Showing posts with label rotor blade. Show all posts
Showing posts with label rotor blade. Show all posts
Friday, February 4, 2011
Vertex Electronic Distributor (2 Wire Unit with Ground)
6:34 PM by onesecond
·
0
comments
Labels: ballast resistor, engine crankshaft, Other, rotor, rotor blade, spark plug wire, spark plug wires, Step
Labels: ballast resistor, engine crankshaft, Other, rotor, rotor blade, spark plug wire, spark plug wires, Step
Saturday, January 29, 2011
Chevrolet V8 Distributor Installation Instructions with Mechanical and Vacuum Advance
2:52 AM by onesecond
·
0
comments
Labels: Chevrolet, chevrolet v8, distributor shaft, position, rotor, rotor blade, spark plug wire, spark plug wires
Labels: Chevrolet, chevrolet v8, distributor shaft, position, rotor, rotor blade, spark plug wire, spark plug wires
These instructions will help you to install a Summit Racing 850050, 850055 or 850205
How to Install the Distributor
1. If the distributor to be replaced has not already been removed from the engine, remove its cap. Do not remove the spark plug wires at this time.
2. Crank the engine slowly until the rotor blade aims at a fixed point on the engine or firewall. Note this point for future reference.
How to Install the Distributor
1. If the distributor to be replaced has not already been removed from the engine, remove its cap. Do not remove the spark plug wires at this time.
2. Crank the engine slowly until the rotor blade aims at a fixed point on the engine or firewall. Note this point for future reference.
Subscribe to:
Posts (Atom)
