If you choose to not follow these detailed instructions, at a minimum, don't overlook the following; items:
1. Set the timing to the new spec, which may be different from the original spec, (new spec; is 18 degrees BTDC at 650 rpm)
2 Install a 12 volt electronic ignition coil
3. Change the spark plug gap to the new spec (0.039"-0,043"),
4. Bypass or remove the ballast resistor from the ignition circuit
Showing posts with label ballast resistor. Show all posts
Showing posts with label ballast resistor. Show all posts
Tuesday, March 8, 2011
Datsun 2407 12V EtectroittC Ignition Distributor Installation Instructions
12:01 AM by onesecond
·
0
comments
Labels: ballast resistor, electronic distributor, PDF Download, spark plug gap, spec, volt, volt coil, wire hook
Labels: ballast resistor, electronic distributor, PDF Download, spark plug gap, spec, volt, volt coil, wire hook
Friday, February 4, 2011
Vertex Electronic Distributor (2 Wire Unit with Ground)
6:34 PM by onesecond
·
0
comments
Labels: ballast resistor, engine crankshaft, Other, rotor, rotor blade, spark plug wire, spark plug wires, Step
Labels: ballast resistor, engine crankshaft, Other, rotor, rotor blade, spark plug wire, spark plug wires, Step
Old Distributor Removal:
Step 1-Disconnect the coil trigger wire coming from the distributor to the negative (-) side of the ignition coil at the coil terminal. Disconnect the wire supplying current to the positive side (+) of the ignition coil. There may be two wires on this terminal, one from the ballast resistor and one from the starter solenoid. The ballast resistor should have one wire left, the
Step 1-Disconnect the coil trigger wire coming from the distributor to the negative (-) side of the ignition coil at the coil terminal. Disconnect the wire supplying current to the positive side (+) of the ignition coil. There may be two wires on this terminal, one from the ballast resistor and one from the starter solenoid. The ballast resistor should have one wire left, the
Subscribe to:
Posts (Atom)
